Low Roll™ Distraction Device® Reloadable Training Body

MODEL: 8933T SKU: 1162539 PART:

The Defense Technology® Low Roll™ Training Body is a replica of the Low Roll™ Distraction Device® body. The hex cut end cap design reduces the roll effect when deployed. The training body is powder coated military training blue to be easily distinguish from operational devices. This body will only accept the 1697 series of training fuzes and has an unlimited life-cycle of use. The use of eye, hearing and glove protection is strongly encouraged. When deploying, do not block the end caps.

//VIEW SDS


Images

Low Roll™ Distraction Device®  Reloadable Training Body,

The Defense Technology® Low Roll™ Training Body is a replica of the Low Roll™ Distraction Device® body. The hex cut end cap design reduces the roll effect when deployed. The training body is powder coated military training blue to be easily distinguish from operational devices. This body will only accept the 1697 series of training fuzes and has an unlimited life-cycle of use. The use of eye, hearing and glove protection is strongly encouraged. When deploying, do not block the end caps.

//VIEW SDS


Read More

Details

Product Actions

Add-on options

Additional Information

Print

STORAGE OF DISTRACTION DEVICES® AND STINGER® GRENADES

Poor storage conditions will significantly reduce the shelf life of Distraction Device® and Stinger® products, resulting in the replacement of the product sooner than necessary or the possible use of defective products. Humidity and heat are the two most damaging factors that destroy Distraction Devices and Stingers.

  • The projectiles and grenades should be stored in a controlled atmosphere with temperatures between 60 degrees Fahrenheit to 75 degrees Fahrenheit with less than 60% relative humidity.
  • Munitions should remain sealed in their shipping containers until they are to be used or placed in a call out box.
  • Never store the grenades and projectiles in the trunk of a car for prolonged periods. The heat may cause the munitions to deteriorate. Exposure to high temperatures can cause the agent to melt, plugging the ports. The unit then has the potential for becoming a fragmentation grenade.

The worst situation for munitions is changes from extreme cold to hot or vice versa.

  • Storage for 24 hours or more is not recommended for temperatures below –20 degrees Fahrenheit especially in high moisture situations. The munitions may still perform but perhaps at a diminished level.
  • Black Powder rounds are more sensitive to cold than smokeless rounds.
  • Pyrotechnic grenades are the least sensitive to colder temperatures because of their chemical makeup.

Stored munitions should be inspected for physical integrity and a representative sample functioned twice a year. Munitions that have surpassed the warranty of 5 YEARS should be replaced.

DISPOSAL OF CHEMICAL AGENTS

The following information is intended only to provide general information for our customers. It is extremely important that anyone using our chemical products comply with all applicable environmental laws and regulations. We recommend that you consult with appropriate legal counsel or governmental authorities prior to disposing of any of our chemical products. 

In 1976, Congress enacted a law entitled, The Resource Conservations and Recovery Act of 1976 (RCRA). This law was intended to protect human health and the environment from imprudent disposal of “hazardous wastes.”

Outdated or otherwise unusable pyrotechnic items are considered “hazardous waste” under RCRA and are assigned the EPA hazardous waste code of D00 1 due to their ignitable characteristic. Disposal of these items must be done in accordance with all applicable Federal and/or State laws. Many states have hazardous waste management programs that are much more stringent than Federal law. For this reason, you should check with the EPA Regional Office to determine to what extent these laws apply to you.